Sunday, 15 April 2012

Almost ready for the track...

(Friday)  It's been a busy two days spent sorting out lot's of minor but essential pre-track day jobs

Puncture Repair
Luckily the nail didn't puncture the tyre. It was on the outer edge so it wouldn't have been repairable had it gone all the way in - result!




ECU Diagnostic
Bob (Mechanic) noticed the service & air bag lights illuminated on the dash. He was keen to try out his new ECU scan tool and it wasn't going to cost us anything, so he plugged it in and scanned away. All clear except for the side air bag circuit which will soon be removed anyway.

Suspension/Tracking/Tyres
Kris (Mechanic) lifted the car on the ramps so we could investigate possible causes for the car pulling to the right under acceleration. Track rod ends, ball joints and bushes all seem solid enough, but the tyre pressures were slightly out and this seems to have resolved the problem.

Exhaust Mount
As i drove up the steep slope into the garage car park i managed to pull one of the exhaust mounts off! We replaced this and cable tied it on for extra support.

(Saturday) The sun is out, so over to my Dad's house today for more tinkering to the Clio.

Faulty bonnet catch
One minute it's popping up at 40mph, then it doesn't open at all! After some time and moderately foul use of the English language, we managed to get the bonnet open.We completely removed the primary catch mechanism, cleaned it up with some WD40 and adjusted the bolt hole position. Job done!

Front Bumper Alignment
As mentioned in an earlier post the bolts had pulled through the plastic, meaning it was held on by plastic clips alone and occasionally the bumper would pop out from under the arches. Not ideal, so we used the existing bolt holes, new nuts, bolts and over sized washers to keep it secure and tidy.

We got the intended jobs finished with time to spare, so we spent some time tidying up the engine bay, replacing missing nuts, bolts and cable tidies as we went. The car is now safe to drive! The only job left to do before we hit the track is to replace the timing belt, water pump and dephaser pulley :)


(Above) Dad taking pride in his work by buffing up the intake manifold using a power drill attachment :)

No comments:

Post a Comment